JapCarForum Car Manufacturers Lexus/Toyota IS200 / IS300 / SPORTCROSS / Altezza Supercharging & Turbo Modifications Stage 2 Supercharger upgrade

Stage 2 Supercharger upgrade

Stage 2 Supercharger upgrade

Pages (3): Previous 1 2 3
dimis
Posting Freak
3,795
04-06-2020, 04:45 AM
#21
reganlives Thanks for the input guys...looks like this is going to end up costing a lot more than I thought! So what if I were to just use a standard pulley? I know that this would leave me with less power but where would I stand then? Dimis, would I still need to carry out the exhaust mods you mentioned etc?

with the standard pulley, you should be ok, no exhaust tuning is needed. Just check the condition of your precats on the exhaust manifold. Pre-cats tend to collapse with time and block the exit of the exhaust manifold.

LEXUS IS200 - The most fun car to go sideways
dimis
04-06-2020, 04:45 AM #21

reganlives Thanks for the input guys...looks like this is going to end up costing a lot more than I thought! So what if I were to just use a standard pulley? I know that this would leave me with less power but where would I stand then? Dimis, would I still need to carry out the exhaust mods you mentioned etc?

with the standard pulley, you should be ok, no exhaust tuning is needed. Just check the condition of your precats on the exhaust manifold. Pre-cats tend to collapse with time and block the exit of the exhaust manifold.


LEXUS IS200 - The most fun car to go sideways

dimis
Posting Freak
3,795
04-06-2020, 04:47 AM
#22
is300_dino one thing ive learnt from people who have done similar projects is to take the total cost of what you think it will cost, then double or tripple your original figure and you should just have enough to cover the costs.

I agree with you mate, tuning is not a cheap hobby and always costs more than you plan....

LEXUS IS200 - The most fun car to go sideways
dimis
04-06-2020, 04:47 AM #22

is300_dino one thing ive learnt from people who have done similar projects is to take the total cost of what you think it will cost, then double or tripple your original figure and you should just have enough to cover the costs.

I agree with you mate, tuning is not a cheap hobby and always costs more than you plan....


LEXUS IS200 - The most fun car to go sideways

reganlives
Posting Freak
1,230
04-06-2020, 05:01 AM
#23
dimis I agree with you mate, tuning is not a cheap hobby and always costs more than you plan....

Same goes for any type of modifying!

Whats the best way to check the precats?
reganlives
04-06-2020, 05:01 AM #23

dimis I agree with you mate, tuning is not a cheap hobby and always costs more than you plan....

Same goes for any type of modifying!

Whats the best way to check the precats?

dimis
Posting Freak
3,795
04-06-2020, 08:15 AM
#24
You just to dismantle the exhaust manifold and see if any peaces of
Powder will fall out

LEXUS IS200 - The most fun car to go sideways
dimis
04-06-2020, 08:15 AM #24

You just to dismantle the exhaust manifold and see if any peaces of
Powder will fall out


LEXUS IS200 - The most fun car to go sideways

reganlives
Posting Freak
1,230
05-06-2020, 02:32 AM
#25
Thanks Dimis. Picked up the charger last night and am getting the original smaller pulley as well so that will give me a bit of headroom and then when I'm ready I can do the full stage 2 upgrade.
reganlives
05-06-2020, 02:32 AM #25

Thanks Dimis. Picked up the charger last night and am getting the original smaller pulley as well so that will give me a bit of headroom and then when I'm ready I can do the full stage 2 upgrade.

rob
Senior Member
720
05-06-2020, 07:10 AM
#26
For the bolts ........ if its the original bolts still installed then they may have threadlock - 2 of mine did, use a GOOD screwdriver and see if they turn. If not u need to heat it a bit.



For replacements two options, replace the originals with a high quality bolt or replace with something like a 5mm imnstead, but of course you need to redrill and tap the holes.


Sent from my GT-I9300 using Tapatalk 2
rob
05-06-2020, 07:10 AM #26

For the bolts ........ if its the original bolts still installed then they may have threadlock - 2 of mine did, use a GOOD screwdriver and see if they turn. If not u need to heat it a bit.



For replacements two options, replace the originals with a high quality bolt or replace with something like a 5mm imnstead, but of course you need to redrill and tap the holes.


Sent from my GT-I9300 using Tapatalk 2

196
26-04-2021, 11:42 AM
#27
How are you getting on with stage two? Does anyone know what bhp can be gained with stage two with pistons upgraded too?


Sent from my iPhone using Tapatalk
lexusdaydreaming
26-04-2021, 11:42 AM #27

How are you getting on with stage two? Does anyone know what bhp can be gained with stage two with pistons upgraded too?


Sent from my iPhone using Tapatalk

Pages (3): Previous 1 2 3
Recently Browsing
 1 Guest(s)
Recently Browsing
 1 Guest(s)
Related Threads…
Replies 20
Views 1,694
29-05-2023, 05:08 PM
Last Post by Mikedaddy
Replies 6
Views 731
23-05-2023, 12:26 AM
Last Post by ashj25839
Replies 1
Views 473
06-04-2023, 02:00 AM
Last Post by Sparkystav
Replies 24
Views 959
12-01-2023, 11:53 AM
Last Post by Lexuspat
Replies 3
Views 120
03-01-2023, 01:19 PM
Last Post by el_bandido
Replies 1
Views 92
27-12-2022, 10:58 PM
Last Post by Lexuspat
Replies 2
Views 420
02-12-2022, 01:57 PM
Last Post by Lexuspat
Replies 3
Views 428
04-11-2022, 05:54 AM
Last Post by beamstezza
Replies 0
Views 59
30-07-2022, 01:49 PM
Last Post by beamstezza