Silverstone S2K
Silverstone S2K
Tidy fix on the cooler panel...
Its nice when a plan comes together
Ok update again
The boot floor was rotten so that has been cut out and a new piece welded in i have also gone around the edges with fibreglass to make sure there are no small gaps where moisture can get in. all the back end has been under sealed with a waxyol sealant, and lastnight got the subframe back in
New piece going in
Ready for the diff
that is rotten isnt it! good to catch it and get it repaired properly though
Thanks guys, back in the garage tonight to fit the diff and drive shafts and start putting in the new bushes in the arms.
Johnh - I think i would be f-ing and cursing if i was there all the time but try to keep it as a hobby so i enjoy it, im up there 2 - 3 times a week so if something is not going right i just lock up and leave have a think then go back at it with a different plan a few days later.
Rabs - Stav - if im going to do it i do it properly, i could of just cut the little bits out and layed some fibreglass over but if i was to sell the car it would affect the value as these s2000's are going up in price since i bought this, you can pick up a cheap example but be prepared to spend some wonga on getting it set up nice.
wont be long until its back on the roads..
keep up the good work bud.
Really impressed with the amount of work going in to the build...
Can't wait to see it back in one piece