Heat Shields = Rattle + Me = Rattle Free
Heat Shields = Rattle + Me = Rattle Free
Before I heading off just nipped under the car to check the size I needed, 10 mins later
![[Image: IMG_20100908_140151.jpg]](https://lh3.ggpht.com/__au3oYfoKLQ/TIeVMaMmNWI/AAAAAAAAPAo/FJM_Q_FyCbw/s512/IMG_20100908_140151.jpg)
Guess what, no more rattles
Toyota Altezza Z Edition.
![[Image: sig.jpg]](http://i5.photobucket.com/albums/y196/todd69/sig.jpg)
Heat shields have been getting worse over the time I've had the car so today I went out to buy some clamps to just tighten them up and see if it would stop the rattles.
Before I heading off just nipped under the car to check the size I needed, 10 mins later
Guess what, no more rattles
Toyota Altezza Z Edition.
Did yours rattle all the time or just at certain RPMs?
P.Lindblom
02-03-2018, 10:21 PM #7What tools did you use to remove the heat shields? I think my pre cats are busted, but before I remove them I just want to make sure it isn't just heat shield rattle I hear.
Did yours rattle all the time or just at certain RPMs?
most of the nuts that hold these on are rotten on most cars. so when you try to undo them they just snap the thread anyway
![[Image: FB_IMG_1474048273787_zpsnbfq6a3s.jpg]](http://i1227.photobucket.com/albums/ee440/davis5835/Mobile%20Uploads/FB_IMG_1474048273787_zpsnbfq6a3s.jpg)
i think the tool he used is called brute force its a very good tool and can be used on many items LOL
most of the nuts that hold these on are rotten on most cars. so when you try to undo them they just snap the thread anyway
P.Lindblom What tools did you use to remove the heat shields? I think my pre cats are busted, but before I remove them I just want to make sure it isn't just heat shield rattle I hear.
Did yours rattle all the time or just at certain RPMs?
The pre cat heat shields are held on by tabs folded over at the edges mate, I used a flat bladed screwdriver when i removed mine, just to fold the tabs back and then pulled them apart,
There is a bit of wadding inside them that looks like heat proof matting, mine had pretty much fallen apart so wasn't doing much?
Lexus IS200 Sport Navigator (Now being stripped again) :blink:
Now Don't Forget The REP!!!
P.Lindblom What tools did you use to remove the heat shields? I think my pre cats are busted, but before I remove them I just want to make sure it isn't just heat shield rattle I hear.
Did yours rattle all the time or just at certain RPMs?
The pre cat heat shields are held on by tabs folded over at the edges mate, I used a flat bladed screwdriver when i removed mine, just to fold the tabs back and then pulled them apart,
There is a bit of wadding inside them that looks like heat proof matting, mine had pretty much fallen apart so wasn't doing much?
Lexus IS200 Sport Navigator (Now being stripped again) :blink:
Now Don't Forget The REP!!!
3 Guest(s)
3 Guest(s)