Anti Roll Bar drop links
Anti Roll Bar drop links
I am major skint at the min, and can't afford the 60quid for a new set.
Can I cut the old ARB off to get the bolt undone?
Help please!!!!!!!!!!
Could anyone tell me how to get these undone?? I am sick of having them sat in the garage, and not being able to get them on the car.
I am major skint at the min, and can't afford the 60quid for a new set.
Can I cut the old ARB off to get the bolt undone?
Help please!!!!!!!!!!
jae 2010 best lexus category show and shine winner
jae 2010 ice outlaw award 2nd place
jae 2011 ice outlaw award 1st place
is300_dino
24-12-2017, 08:55 AM #12just use lots of wd40 and a long handled socket, with a set of mole grips to stop the bolts from spinning for the fronts, the backs just use the socket and wd40. that should do the trick, just be careful not to snap the bolt heads off
jae 2010 best lexus category show and shine winner
jae 2010 ice outlaw award 2nd place
jae 2011 ice outlaw award 1st place
"Life's goal is not to arrive safely at the grave in a well preserved body. But, rather to skid in sideways........
totally worn out and broken, shouting 'Holy ****, WHAT A RIDE!'"
FirebirdPhil
24-12-2017, 09:33 AM #14Plusgas is substantially better then WD40.
"Life's goal is not to arrive safely at the grave in a well preserved body. But, rather to skid in sideways........
totally worn out and broken, shouting 'Holy ****, WHAT A RIDE!'"
get the mole grips as tight as you can and then a bit more (be careful when releasing as the grips will be highly tensioned and will spring out and hurt your hand). make sure you have a proper fitting 14mm socket, dont get angry with it
small jawed molegrips to hold the threaded part of the ball joint, lot of soaking in plusgas or even duck oil, I found this to be just as good.
get the mole grips as tight as you can and then a bit more (be careful when releasing as the grips will be highly tensioned and will spring out and hurt your hand). make sure you have a proper fitting 14mm socket, dont get angry with it
only prob with changing them at a meet is that you do struggle with a seized one and render it useless then they will have to drive home with it in a dodgy condition, I will gladly help you mate and no doubt others will as well
also try the other end, see if they come off easier as they both ends have to be undone.
only prob with changing them at a meet is that you do struggle with a seized one and render it useless then they will have to drive home with it in a dodgy condition, I will gladly help you mate and no doubt others will as well
3 Guest(s)
3 Guest(s)
Views 1,171
Last Post by