Stainless steel Ebay decat manifold + cat back exhaust system [any good?]
Stainless steel Ebay decat manifold + cat back exhaust system [any good?]
Decat manifold: http://www.ebay.co.uk/itm/350522855561
![[Image: %24(KGrHqZ,!joE8NDvS1ziBPD,g8G8I!~~60_12.JPG]](http://i.ebayimg.com/00/s/NjY5WDEwMDA=/%24(KGrHqZ,!joE8NDvS1ziBPD,g8G8I!~~60_12.JPG)
Cat back exhaust system: http://www.ebay.co.uk/itm/230630581138
![[Image: %24(KGrHqR,!oQE8V(DdozOBPT7,GZKR!~~60_12.JPG]](http://i.ebayimg.com/00/s/MzExWDQwMA==/%24(KGrHqR,!oQE8V(DdozOBPT7,GZKR!~~60_12.JPG)
I know the cat back exhaust needs an M18 x 1,5 lambda boss, but that's not a problem.
P.Lindblom
07-02-2019, 05:09 AM #1Does anyone know if these are any good? I've been asked to fit them to the "race car".
Decat manifold: http://www.ebay.co.uk/itm/350522855561
Cat back exhaust system: http://www.ebay.co.uk/itm/230630581138
I know the cat back exhaust needs an M18 x 1,5 lambda boss, but that's not a problem.
jay_russell
07-02-2019, 10:13 AM #3as it's not a road car why not just remove the old set up and chop out the cats and have a new section welded in there. they are the same size of pipes so there will be no diference. even better have them cut out the cats and from there build a new system 4" all the way. even think about double exhausts. i can say that the company that did mine here in gbg was very good. used them for a few other bits and they are 100%.
have to excuse sound quality recorded on a phone
http://www.youtube.com/watch?v=iA2Y4mvEW...ata_player
have to excuse sound quality recorded on a phone
Only thing i would say is that it sounds raspy at the front of the cat pipe, no idea why will get a vid at some point. it dose it when i start the car as revs drop it goes then if i go over 3krpm it starts to rasp again then starts fading at about 5500-6krpm or might just be engine is louder so it sound quieter?
it fits well and looks alot better and gives a deeper tone, but i still got center sliencer, and a blitz rear.
![[Image: 46032_548210708527052_942106859_n.jpg]](https://sphotos-d.ak.fbcdn.net/hphotos-ak-ash3/p206x206/46032_548210708527052_942106859_n.jpg)
lookatmybiceps
09-02-2019, 10:53 AM #7I have the manifold and the highflow cat pipe, seems ok for the price! had to change supercharger braket as pipe closer so cant have the bracket pipe bit, hard to explain if you got one will know the piece i mean.
Only thing i would say is that it sounds raspy at the front of the cat pipe, no idea why will get a vid at some point. it dose it when i start the car as revs drop it goes then if i go over 3krpm it starts to rasp again then starts fading at about 5500-6krpm or might just be engine is louder so it sound quieter?
it fits well and looks alot better and gives a deeper tone, but i still got center sliencer, and a blitz rear.
lookatmybiceps
09-02-2019, 10:56 AM #8Ps. only had on a few days will give an update after week or so.
lookatmybiceps
10-02-2019, 10:48 AM #10another note, the lower sensor on manifold is very close to body of car hard to explain will get pic also wire needs to be tight or cut and extended as slightly further away than stock.
3 Guest(s)
3 Guest(s)
Views 461
Last Post by
Views 220
Last Post by
Views 378
Last Post by
Views 310
Last Post by
Views 794
Last Post by
Views 342
Last Post by