yet more problems with the scooby :(
yet more problems with the scooby :(
First take the two 10mm bolts holding the washer bottle out then lift the bottle up out of the way you have to take the power plug off first then undo the coil packs pull out slip the socket inside then put the extension on then the ratchet undo to finger tip tight then take off the ratchet an undo the rest of the way by fingers obviously reverse to put back but remove the rubber grommet from the plug socket before you start or you will tighten it all up an not be able to get the socket out ha ha.
On the other side take the induction kit and brackets off removing these two bits first will save your knuckles
You'll need 12mm spanner and obviously a small plug socket and Small extension bar for it.
First take the two 10mm bolts holding the washer bottle out then lift the bottle up out of the way you have to take the power plug off first then undo the coil packs pull out slip the socket inside then put the extension on then the ratchet undo to finger tip tight then take off the ratchet an undo the rest of the way by fingers obviously reverse to put back but remove the rubber grommet from the plug socket before you start or you will tighten it all up an not be able to get the socket out ha ha.
On the other side take the induction kit and brackets off removing these two bits first will save your knuckles
Sorry mate... i found it, wasnt that one but i was yellow, the car cut out on me earlier and was dead absolutley nothin happened when i turned the key then all of a sudden just burst into life, then happened agean when i found my obd port, i pulled apart my dash and found a wire from the turbo timer had frazzled so ive took it out completely see what happens... also i took my afm off and cleaned it out and hasnt helped the boost problem
5 Guest(s)
5 Guest(s)
Views 1,089
Last Post by
Views 1,454
Last Post by
Views 732
Last Post by