is200 ecu pinouts wanted
is200 ecu pinouts wanted
When you are at the start you can fully press the gas pedal but the engine will only rev to the rpm you set. For example 3000rpm
As soon as the e manage sees that the vehicle is moving the rpms go up like normal.
Like this you can pull with full boost from the start.
Thats why i needed the vehicle speed signal wire
The launch control on the emanage is a great option for drag races.
When you are at the start you can fully press the gas pedal but the engine will only rev to the rpm you set. For example 3000rpm
As soon as the e manage sees that the vehicle is moving the rpms go up like normal.
Like this you can pull with full boost from the start.
Thats why i needed the vehicle speed signal wire
What would do this?
beamstezza
20-02-2022, 04:06 AM #32Cool I was thinking about putting in antlag or similar for the backfiring from the exhaust.
What would do this?
beamstezza
20-02-2022, 04:08 AM #33I would have thought that there would have been a complete pin out diagram but I found it impossible to find one. Total headache
beamstezza
21-02-2022, 11:59 AM #34Went looking at the wiring today and I don't even have the c plugs? Can anyone shed light on this?
![[Image: LexuS-Copy.jpg]](http://i65.photobucket.com/albums/h204/Sparkystav/LexuS-Copy.jpg)
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
21-02-2022, 02:18 PM #35The C plug is only on the Auto ECU
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
I don't have it on my auto loom nor do I have pins on my auto ecu.
I have A B D E pins on ECU and plugs for the auto.
The manual ECU only has the above pins also.
beamstezza
21-02-2022, 03:41 PM #36Hi mate.
I don't have it on my auto loom nor do I have pins on my auto ecu.
I have A B D E pins on ECU and plugs for the auto.
The manual ECU only has the above pins also.
![[Image: 971dd3d28b3596f74faead604669c3f4.jpg]](http://tapatalk.imageshack.com/v2/15/04/04/971dd3d28b3596f74faead604669c3f4.jpg)
![[Image: 6cdab87f9249ff70ff5714b53f4306da.jpg]](http://tapatalk.imageshack.com/v2/15/04/04/6cdab87f9249ff70ff5714b53f4306da.jpg)
beamstezza
23-02-2022, 01:20 PM #39Question. If I was to just use auto ECU what wiring would need doing?
1 Guest(s)
1 Guest(s)
Views 469
Last Post by
Views 700
Last Post by
Views 1,183
Last Post by
Views 305
Last Post by
Views 352
Last Post by
Views 459
Last Post by
Views 488
Last Post by
Views 7,723
Last Post by
Views 1,295
Last Post by