More Problems.....
More Problems.....
Lexusboy Steve what sort of feedback would you give this reader?Excellent. Cheap and does the job. Doesn't do anything fancy, but it reads the codes, and lets you reset them. Could easily pay for itself in a single use if it saves you paying a garage to tell you what's wrong with your car.
![[Image: Sig-enginebay.jpg]](http://i5.photobucket.com/albums/y179/SteveHammatt/Sig-enginebay.jpg)
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
07-09-2016, 11:59 PM #21Lexusboy Steve what sort of feedback would you give this reader?Excellent. Cheap and does the job. Doesn't do anything fancy, but it reads the codes, and lets you reset them. Could easily pay for itself in a single use if it saves you paying a garage to tell you what's wrong with your car.
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
Last night, it was getting late, and dark and my mains power light was quite ****.
Basically I had a brain wave, and figured out why my trc, abs and engine check light was on.
The is200 comes with abs trc connectors on the outer edge of the wings. I had to disconnect these connectors to renove the broken front end. The wiring loom runs on the inside of the left and right headlight support bars.
The engine check light was caused by a snesor ontop of the airbox
UPDATE
Last night, it was getting late, and dark and my mains power light was quite ****.
Basically I had a brain wave, and figured out why my trc, abs and engine check light was on.
The is200 comes with abs trc connectors on the outer edge of the wings. I had to disconnect these connectors to renove the broken front end. The wiring loom runs on the inside of the left and right headlight support bars.
The engine check light was caused by a snesor ontop of the airbox
But stll confused on the bizzar radiator issue.
I started it this morning external temprature was about 8c. I let it warm up and idle, the temp went up slowly and the gauge moved slowly, eventually it reached 5 bars off the bottom, and I felt the pipes, top pipe was warm and the right hand side of the radiator was warn, the bottom pipe closer to the water pump was warm but the end that goes on the radiator was cold.
I had set the heaters on screen, and the warmest setting with fans on full speed.
Hot air was comming out from them
Now I have no errors on the dash.
But stll confused on the bizzar radiator issue.
I started it this morning external temprature was about 8c. I let it warm up and idle, the temp went up slowly and the gauge moved slowly, eventually it reached 5 bars off the bottom, and I felt the pipes, top pipe was warm and the right hand side of the radiator was warn, the bottom pipe closer to the water pump was warm but the end that goes on the radiator was cold.
I had set the heaters on screen, and the warmest setting with fans on full speed.
Hot air was comming out from them
ibby Basically I had a brain wave, and figured out why my trc, abs and engine check light was on.
The is200 comes with abs trc connectors on the outer edge of the wings. I had to disconnect these connectors to renove the broken front end. The wiring loom runs on the inside of the left and right headlight support bars.
The engine check light was caused by a snesor ontop of the airbox
Well done for fixing it :thumbup:
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
08-09-2016, 01:44 AM #24ibby Basically I had a brain wave, and figured out why my trc, abs and engine check light was on.
The is200 comes with abs trc connectors on the outer edge of the wings. I had to disconnect these connectors to renove the broken front end. The wiring loom runs on the inside of the left and right headlight support bars.
The engine check light was caused by a snesor ontop of the airbox
Well done for fixing it :thumbup:
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
08-09-2016, 02:23 AM #26I don't really know, sorry, I'll see if I can check mine. But the thermostat has the opening temperature imprinted on it, and yes, it will be around 80 degrees C (probably 82).
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
reganlives
08-09-2016, 04:59 AM #27hmm this is an interesting thread...sorry to hijack it but...my TRC light has been flashing for ages now as some ppl may know but I've not had a chance to get it sorted but have had codes read and nothing came back so possibly one of the sensors but dont know which one but.....my car had frontal damage so could it be one of the front sensors? I really need to get my traction control working before winter really kicks in.
reganlives hmm this is an interesting thread...sorry to hijack it but...my TRC light has been flashing for ages now as some ppl may know but I've not had a chance to get it sorted but have had codes read and nothing came back so possibly one of the sensors but dont know which one but.....my car had frontal damage so could it be one of the front sensors? I really need to get my traction control working before winter really kicks in.Which TRC light is flashing, the TRC light itself (the one showing a car skidding), or the TRC OFF light ?
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
08-09-2016, 05:59 AM #28reganlives hmm this is an interesting thread...sorry to hijack it but...my TRC light has been flashing for ages now as some ppl may know but I've not had a chance to get it sorted but have had codes read and nothing came back so possibly one of the sensors but dont know which one but.....my car had frontal damage so could it be one of the front sensors? I really need to get my traction control working before winter really kicks in.Which TRC light is flashing, the TRC light itself (the one showing a car skidding), or the TRC OFF light ?
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
08-09-2016, 06:15 AM #30See this procedure for how to check the speed sensors.
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
1 Guest(s)
1 Guest(s)
Views 489
Last Post by
Views 628
Last Post by
Views 2,155
Last Post by
Views 448
Last Post by
Views 9,105
Last Post by
Views 1,373
Last Post by