Wheel spacers help needed!!
Wheel spacers help needed!!
So your tuckin 15's, that's cute but come back to me when you get some proper size wheels
Can anybody tell my if 9.5mm spacers will be ok to run on my mr2 with the standard bolts or are they going to be too short and dangerous to run if not does anybody know where I can get some hubcentric ones cheap for my mr2
So your tuckin 15's, that's cute but come back to me when you get some proper size wheels
http://www.ebay.co.uk/itm/Toyota-wheel-s...43a4a896d2
http://www.ebay.co.uk/itm/Toyota-Wheel-S...564240ddad
then your spacers will be no problems
jay_russell
05-09-2018, 07:49 AM #3why not just change to longer bolts
http://www.ebay.co.uk/itm/Toyota-wheel-s...43a4a896d2
http://www.ebay.co.uk/itm/Toyota-Wheel-S...564240ddad
then your spacers will be no problems
all you need is a hammer to knock the old ones out.
some locktight
and a open nut the same as the stud and a washer or 2.
you put the new stud in place with a bit of locktight
then use the open nut to pull it into place from the outside.
jay_russell
05-09-2018, 08:11 AM #5yer but it takes about 15 minutes a wheel.
all you need is a hammer to knock the old ones out.
some locktight
and a open nut the same as the stud and a washer or 2.
you put the new stud in place with a bit of locktight
then use the open nut to pull it into place from the outside.
Chris0121 Haven't you got to take all the hubs apart though need a quick bolt on fix to e fair
I don't think it's very hard. But best to get advice from the likes of Boost (he will probably comment when he sees this) as he is running massive wheels and a wide body kit on his V6 MR2.
![[Image: tempsig2.jpg]](http://i121.photobucket.com/albums/o227/84stoney/tempsig2.jpg)
ad: It was a tough call to make, but the Supercharged IS200 is being retired. ad:Chris0121 Haven't you got to take all the hubs apart though need a quick bolt on fix to e fair
I don't think it's very hard. But best to get advice from the likes of Boost (he will probably comment when he sees this) as he is running massive wheels and a wide body kit on his V6 MR2.
ad: It was a tough call to make, but the Supercharged IS200 is being retired. ad:
All this to fit my new wider arches so much hassle 10j wheels just dont like being fitted on mr2's lol
So your tuckin 15's, that's cute but come back to me when you get some proper size wheels
Just spoke to boosst he said he thinks that spacers over 5mm will wear the bearings out quite quickly
All this to fit my new wider arches so much hassle 10j wheels just dont like being fitted on mr2's lol
So your tuckin 15's, that's cute but come back to me when you get some proper size wheels
jay_russell
05-09-2018, 10:34 AM #9it's not a hard job, it's only the backs and if you can chance disks then this is about the same as, better with longer bolts that add on spacers as the bearings will get more wear just as is said. this is the kind if thing you can do at home,
1 Guest(s)
1 Guest(s)
Views 365
Last Post by
Views 1,506
Last Post by
Views 599
Last Post by
Views 610
Last Post by
Views 712
Last Post by
Views 702
Last Post by
Views 1,129
Last Post by