Help With a Small Project
Help With a Small Project
You don't need to take the barrel apart, just the speedo cover off
2 screws above the speedo, one at the bottom below the steering wheel, and the cover comes off.
You can then easily get to and tap off the ignition ring.
Ok I completed my small project, but whilst doing it ive somehow created another problem. The air bag light has come on now, im not sure why, I had been checking some fuses but if there is an air bag fuse would taking it out and putting it back trigger the light to come on?
How do I get it off?
google around how to reset airbag light on lexus (same as toyota)
this is what I found on a quickie...
STEP 1: Turn the ignition on for approximately 20 seconds, but do not start the engine.
STEP 2: Stick a wire or paper clip in the Tc & E1 pinholes of the DLC2.
STEP 3: If the light blinks continuosly or code 22 (two fast blinks, a pause, then two more fast blinks), then you can probably manually cancel the warning light. If it is any other code, you need to trouble shoot it and fix the problem.
STEP 4: To clear the code connect two wires to Tc and AB of the DLC2.
STEP 5: Turn the ignition to ACC or ON and wait approximately 6 seconds.
STEP 6: Start with the Tc terminal and apply a wire to body ground alternately to Tc and AB twice each in cycles of 0.5 - 1.0 seconds.
STEP 7: Finally keep Tc to ground. If the clearing is done properly, then the airbag light will blink in 50 msec incriments continously. If it did not, then you didn't ground the Tc and AB properly. Repeat the process. The procedure may take between 3 to 15 attempts to work.
Hmm not sure about that guide. Isn't that for obd 1 cars? Rather than the IS that's obd2.
http://bahamutcars.free.fr/workshop/IS_9...i_0287.pdf
2nd page
I have not tried it, but reading other posts, seems to be working for lot of toyotas and lexus.