Speedo Cluster Help
Speedo Cluster Help
I had my speedo out yesterday modifying the lights guides etc to make it look better but now all my needles are wrong. I have managed to sort the Rev and speedo out ok but the fuel guage, temp, mpg and voltage are all wrong. Is there a way to reset the clocks so they all read right again or a trick to putting the needles back in the right plasce? I have tried putting them on when it's all off and put them to their lowest possible point and tried putting them on when all the dials are connected and powered up but I cannot see to get them to sit right.
Many thanks all
Ross
Hi All,
I had my speedo out yesterday modifying the lights guides etc to make it look better but now all my needles are wrong. I have managed to sort the Rev and speedo out ok but the fuel guage, temp, mpg and voltage are all wrong. Is there a way to reset the clocks so they all read right again or a trick to putting the needles back in the right plasce? I have tried putting them on when it's all off and put them to their lowest possible point and tried putting them on when all the dials are connected and powered up but I cannot see to get them to sit right.
Many thanks all
Ross
If so it will be hard to get them back in the right place.
temp can be sorted by letting the car warm up, then sticking the needle on in the middle position.
fuel can be done by filing the tank and then putting it at the top.
voltage, have the engine running and put it just under 14v
not sure about mpg though
sprinter2012
22-03-2019, 12:31 PM #2Did you take the needles off the motors?
If so it will be hard to get them back in the right place.
temp can be sorted by letting the car warm up, then sticking the needle on in the middle position.
fuel can be done by filing the tank and then putting it at the top.
voltage, have the engine running and put it just under 14v
not sure about mpg though
Ross
Yeah i did as i needed to get the dials themselves off to scrape off the light guidss on them. Got temp and voltage about right, speedo and revs are good now just got to sort the mpg, can somone take a pic of their mpg with the car running and stationary
Ross
reco2k Yeah i did as i needed to get the dials themselves off to scrape off the light guidss on them. Got temp and voltage about right, speedo and revs are good now just got to sort the mpg, can somone take a pic of their mpg with the car running and stationary
Ross
Just looked up a pic from when I did my LED speedo, when the engine is running and the car is stationary the needle rests on the stopper.
But it's going to be VERY hard to get the mpg right from a picture because you'd have to have the throttle in exactly the same position, same speed, same angle of road surface etc.
sprinter2012
22-03-2019, 01:22 PM #4reco2k Yeah i did as i needed to get the dials themselves off to scrape off the light guidss on them. Got temp and voltage about right, speedo and revs are good now just got to sort the mpg, can somone take a pic of their mpg with the car running and stationary
Ross
Just looked up a pic from when I did my LED speedo, when the engine is running and the car is stationary the needle rests on the stopper.
But it's going to be VERY hard to get the mpg right from a picture because you'd have to have the throttle in exactly the same position, same speed, same angle of road surface etc.
1 Guest(s)
1 Guest(s)
Views 497
Last Post by
Views 724
Last Post by
Views 723
Last Post by
Views 1,100
Last Post by
Views 2,648
Last Post by
Views 2,850
Last Post by