Little write up on the evolution of my car
Little write up on the evolution of my car
Ooh one thing that might do it interference on the ecu lines I moved my aem fix to inside the car from the bay and the car worked fine but then stopped playing ball had to take it back out again and me it back to the engine bay that cured the problem
Just a thought
Mapping issue perhaps?
I had similar issues on my old standalone and tweaks to the map helped massively.
Hmm it's n idea, I did use most of the standard loom to avoid that. And the resistance from the injectors/igniters back to the ecu is less than 1ohm in each case.
Just seems odd it was running fine then stopped, hadnt moved anything in the meantime.
speedfreek Mapping issue perhaps?
I had similar issues on my old standalone and tweaks to the map helped massively.
speedfreek Mapping issue perhaps?
I had similar issues on my old standalone and tweaks to the map helped massively.
Sparkystav Just seems odd it was running fine then stopped, hadnt moved anything in the meantime.
Sparkystav Just seems odd it was running fine then stopped, hadnt moved anything in the meantime.
mattlaw Are you running a map or maf sensor?
mattlaw Are you running a map or maf sensor?
Rabster Couldn't a cable have moved to cause the problems and is now hanging against the loom causing a issue
Rabster Couldn't a cable have moved to cause the problems and is now hanging against the loom causing a issue