Little write up on the evolution of my car
Little write up on the evolution of my car
Tbh I dont know.
Just checked the parts catalogue...looks like the transfer housing is on the rear of the gearbox, with a central rear output for the rear diff (like most RWD boxes) and an offset output facing forwards on the driver's side, which goes forwards with a short prop to a separate front diff.
Do you have the 4wd altezza Gita parts list?
Hmm so it could work. Would need a front axle though, to fit around the engine.
Ideas ideas.
Some more information on the 4WD
http://z4.invisionfree.com/lexusaltezzac.../t4446.htm
On the Gita (1G or 2J) the diff is on the driver's side like the Hilux, but the passenger side front driveshaft goes through a channel in the upper sump (the aluminium part not the steel oil pan).
On the Hilux it doesn't. Hilux is rear sump so the front diff sits just forwards of that.
Can you fit a 1G-FE sump to a 1G-GTE? Assuming your engine sits in the same place as the stock 1G then you could swap the sump on, and run a driveshaft straight through the engine!
yes i run a 1gfe sump on mine, as theres a couple of versions of the GTE sump, one rare winged version, but the majority are central sumps and no good for fitting into the IS200
have you seen these pages?
front axle housing and diff setup - http://catalog.toyotaqsp.ru/jp/242110/008/2/4301/1/
mainpage - http://catalog.toyotaqsp.ru/jp/242110/008/2/
ALSO found an actual 4wd box going for cheap as well. New Zealand dollars $580.00
http://www.trademe.co.nz/Browse/Listing....=647469889
or could import one at only £750 for the car could make that back stripping the rest of the parts i expect http://www.tradecarview.com/used_car/jap.../13495848/
is300_dino have you seen these pages?
front axle housing and diff setup - http://catalog.toyotaqsp.ru/jp/242110/008/2/4301/1/
mainpage - http://catalog.toyotaqsp.ru/jp/242110/008/2/
is300_dino ALSO found an actual 4wd box going for cheap as well. New Zealand dollars $580.00
http://www.trademe.co.nz/Browse/Listing....=647469889
or could import one at only £750 for the car could make that back stripping the rest of the parts i expect http://www.tradecarview.com/used_car/jap.../13495848/
is300_dino have you seen these pages?
front axle housing and diff setup - http://catalog.toyotaqsp.ru/jp/242110/008/2/4301/1/
mainpage - http://catalog.toyotaqsp.ru/jp/242110/008/2/
is300_dino ALSO found an actual 4wd box going for cheap as well. New Zealand dollars $580.00
http://www.trademe.co.nz/Browse/Listing....=647469889
or could import one at only £750 for the car could make that back stripping the rest of the parts i expect http://www.tradecarview.com/used_car/jap.../13495848/