upgrading speakers
upgrading speakers
Sparkystav They are alpine crossovers mate, I got exactly the same from alpine when the proper ones broke.
If your replacing the speakers in the front you should have 4, 2 little ones and two that are about 6inch or so. The box splits the signal between the speakers in each door as the big one should be bass and mid. The little ones high and mid
Sparkystav They are alpine crossovers mate, I got exactly the same from alpine when the proper ones broke.
If your replacing the speakers in the front you should have 4, 2 little ones and two that are about 6inch or so. The box splits the signal between the speakers in each door as the big one should be bass and mid. The little ones high and mid
Depends, what do the fronts look like? Like a small sub or a speaker with a little speaker inside it?
Just like a speaker. I'll take a pic tomorrow.
But don't think Jason would have only sold me 2 if I needed 4 for the front.
I maybe need to open the rest of the parcels to make sure.
But think it's only the 2 rears that's there
There should only be 2 rears, that's right,
Get a pic and well see
Trying to do this today. And I must say I don't have a ******* clue what I'm doing! !!!!
I've got the old speaker out. Backing plates made up from mdf. But don't know what to do with the wires.
Anyone ? ?
Where did that go to mate?
There should be two wires going to the speaker. They want to go to the two wires on the black box.
Then the side of the black box with 4 wires. 2 go to the big speaker, 2 to the little speaker you haven't got.
That was plugged into the top of the original speaker
So can't I just use the old tweeters for the 2 that I've not got.
You could but but they aren't matched to the speaker so may not work well