What have you done to your car today?
What have you done to your car today?
Moley Remember to wire brush all the old **** out from the arches before you roll them. And use a heat gun to soften the paint when rolling them
Moley Remember to wire brush all the old **** out from the arches before you roll them. And use a heat gun to soften the paint when rolling them
They are all pretty much the same, just take your time, small increments, and make sure you heat the area
Well yesterday I finally got round to replacing the water pump and cambelt on the landrover what a pig of a job that was.
And today started tinting the rear windows
Sent from my SM-G920F using Tapatalk
Got my ecu back with a bigger map sensor fitted,
Also bought a new alarm/remote start/keyless entry module, already got one that works but wanted something different
Finally got all 4 wheels the same. I like it.
Also rolled my arches with my fancy new arch roller. Pain in the **** as you have to take the caliper off to reach fully around the arch. Cracked the paint a bit, but meh, touch up paint will solve that. Combination of impatience and noobness. Also failed at fitting my auto mirror folding thing. Good day/bad day!
Doh! Did you try the bits I messaged you about?
Pm me where we're at.
Yeah, but it seems to blow a fuse every now and again. So I've took it out for the time being. It's been a busy weekend and I cba with it. I'm gonna triple check everything before the next install when I have a bit more time on my hands. No doubt I'll be PMing you about something I've broken again, but thanks for the help so far, we must be close to cracking it. Probably something stupid, I shoudn't be allowed near car electrics.
No worries, worse case you come to a show with the club and I fit it there....
Sparkystav No worries, worse case you come to a show with the club and I fit it there....
Sparkystav No worries, worse case you come to a show with the club and I fit it there....
No worries I'll sort it!