map light fitting?
map light fitting?
I've found 3 different answers on my.is so does anyone e know what fitting the front map light bulb is on the is300?
It should pop off and drop down on a hinge.
I'll have a look then. I need to order a new bulb, was going to do it while I'm still at work. Do you know what fitting it is?
If its the same as the 200 then you need a flat blade screwdriver to pry it off. If I remember correctly there's 2 tabs which hold it in place. I replaced my standard bulb a couple of years back with an LED panel. Wont go back to standard bulbs again!
Oh yeh, the tabs are between the plastic edging and the roof lining.
here you go dude...
http://my.is/forums/f115/how-change-map-...lb-344377/
Ahh, sorry mate, I'm not too sure what its called but from what I remember when I replaced mine with a led panel it had a 2 pin connector on it like a jumper on a computer motherboard. Dont remember if that then went into some kinda convertor though. I'll take a look when I get a chance if you want.
Right, I've had a look through my emails and purchase history and it was described as T10 BA9s....
Did a quick search on ebay and the best picture showing the fittings is as below...
http://www.ebay.co.uk/itm/T10-501-BA9S-D...3372cfc5d9