DIY custom supercharger parts list
DIY custom supercharger parts list
is200turbo
07-07-2023, 03:15 PM #122Have you got the inlet/outlet mate
Sent from my iPhone using Tapatalk
is200turbo
07-07-2023, 08:36 PM #124It was the beginning of the week wasn't it
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
is200turbo
07-07-2023, 09:48 PM #126That's not good mate, I've got a bloke that's doin my fence and he's like that still waiting for it finishing
Sent from my iPhone using Tapatalk
In the process of rebuilding an M62 for my IS200.
Have been thinking about inlet/outlet manifolds for the charger.
Nothing has materialised yet, but I may be able to get a run of flanges made. Lasercut/Waterjet cut plates to then build your piping onto.
Seeing as the ebayer I had the charger from made the mistake of sending me the Mercedes manifolds aswell for the better price, I've got a nice template to work from.
So, would anyone be interested in this if it should become a "thing"?
Cant give any idea of price yet I'm afraid but shouldn't break the bank...
Cheers,
Danny.
DannyStock
28-07-2023, 01:06 PM #127Hi I'm still a newbie here. So, Hello.
In the process of rebuilding an M62 for my IS200.
Have been thinking about inlet/outlet manifolds for the charger.
Nothing has materialised yet, but I may be able to get a run of flanges made. Lasercut/Waterjet cut plates to then build your piping onto.
Seeing as the ebayer I had the charger from made the mistake of sending me the Mercedes manifolds aswell for the better price, I've got a nice template to work from.
So, would anyone be interested in this if it should become a "thing"?
Cant give any idea of price yet I'm afraid but shouldn't break the bank...
Cheers,
Danny.
![[Image: LexuS-Copy.jpg]](http://i65.photobucket.com/albums/h204/Sparkystav/LexuS-Copy.jpg)
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
28-07-2023, 11:48 PM #128There's a few people looking at the same thing but it's getting the costs reasonable.
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Mine were not a reasonable price... I had to have my flanges 8mm thick to minimize the warping when welding the tube to em. My fabber did a grand job of not buckling them, but I've twisted the **** out of the outlet when I rewelded the spout to it's correct position. Something to keep in mind when having them cut.
These would just be the flange plates though, no piping on them.
It depends whose willing to do the job & how many for how much on their terms atm
Warping could be an issue (something that had slipped my mind until mentioned above). I've got some 5mm plate lying around which seems adequate enough.
But 8mm you say?!
DannyStock
29-07-2023, 11:48 AM #130Cost-wise... I couldn't give any idea.
These would just be the flange plates though, no piping on them.
It depends whose willing to do the job & how many for how much on their terms atm
Warping could be an issue (something that had slipped my mind until mentioned above). I've got some 5mm plate lying around which seems adequate enough.
But 8mm you say?!
18 Guest(s)
18 Guest(s)
Views 1,602
Last Post by
Views 1,092
Last Post by
Views 923
Last Post by