How to fit rear mud flaps???
How to fit rear mud flaps???
There are black plastic bits on the end of your bumper that are held on with three screws.
Remove the screws and plastic bit and fit the mud flaps. But cant remember if this is just for the front ?? But there will be screws like Dean has said on the rear bumper.
Not fitted any to mine, but this was copied from another site,,,
to fit the rear ones properly you have to drill 1 hole into the edge of the plastic bumper, this is to allow fitment of another spring clip nut for a mudguard mounting screw. on the front you remove a little piece of trim about 4 screws i think then just screw the mudguard using existing holes.
0
I've measured them up and it looks like you have to drill a hole into the rear bumper just under where the other bumper trim screw is, theres another hole on the under bit of the bumper as well? not sure I feel confident drilling into the bumper as theres not a lot of room for mistakes