replacing front seats with bucket seats.
replacing front seats with bucket seats.
what is needed to make the swap? i saw something about airbag cancellers plug but i dont know if or how to fit them. and is there anything else i need or can i just do a swap without anything going wrong. all sort the rain thing out later.
lexusdaydreaming
23-11-2021, 05:36 AM #1hi all, i got some nice bucket seats of a friend cheap with side mounts.
what is needed to make the swap? i saw something about airbag cancellers plug but i dont know if or how to fit them. and is there anything else i need or can i just do a swap without anything going wrong. all sort the rain thing out later.
Airbag cancellers are just resistors so easy t fit.
![[Image: LexuS-Copy.jpg]](http://i65.photobucket.com/albums/h204/Sparkystav/LexuS-Copy.jpg)
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
23-11-2021, 09:21 AM #2Your gonna need mounts making up as well.
Airbag cancellers are just resistors so easy t fit.
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
lexusdaydreaming
24-11-2021, 07:29 AM #3dont have steering wheel airbag as itsd aftermarket so only airbag left is passenger one. i drilled my own holes on frame n got one fitted so far i will post pics of install. to be honest it has been very easy for me i dont have good drill or vice so drilling has been difficult but i know if i had that sorted i would of done it with in 2 to 3 hours, i used orignal frame from old seats.
lexusdaydreaming
27-11-2021, 06:44 AM #5i cant seem to post pics anyone know a quick way of doing this. its been a while.
lexusdaydreaming
27-11-2021, 08:31 AM #7only got a few i put on photo bucket but you can see after i strip original seat what i am left with. then i bold side panels to rails and then seat.
lexusdaydreaming
27-11-2021, 08:45 AM #8the way the side panels are in the pic is the same for other side of seat. they are NOT both faceing outwards. i will be getting fabric and foam to cover the panels to tidy it up not bad for a days job i think. and i didnt spend any cash on rails.
I found I was too high when I made a seat mount
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
27-11-2021, 09:59 AM #9How do you find the height mate?
I found I was too high when I made a seat mount
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
lexusdaydreaming
27-11-2021, 10:54 AM #10i think mine is fine, but all i need to do is drill holes lower on the side mounts if i wanted to. it is taken me a bit to get used to but feels much better, next is the harnesses
2 Guest(s)
2 Guest(s)
Views 282
Last Post by
Views 823
Last Post by
Views 624
Last Post by
Views 1,303
Last Post by