JapCarForum Car Manufacturers Lexus/Toyota IS200 / IS300 / SPORTCROSS / Altezza Aircon Compressor Pressure Switch?

Aircon Compressor Pressure Switch?

Aircon Compressor Pressure Switch?

reganlives
Posting Freak
1,230
27-05-2016, 02:55 AM
#1
Where is it as on LOC I been told that it can stick sometimes if the system has been left depressurised for a while???

Cheers
reganlives
27-05-2016, 02:55 AM #1

Where is it as on LOC I been told that it can stick sometimes if the system has been left depressurised for a while???

Cheers

steviewevie
Posting Freak
7,993
27-05-2016, 03:06 AM
#2
It's in front of the radiator. See this diagram and this one too.

[Image: Sig-enginebay.jpg]
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
27-05-2016, 03:06 AM #2

It's in front of the radiator. See this diagram and this one too.


[Image: Sig-enginebay.jpg]
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !

reganlives
Posting Freak
1,230
27-05-2016, 03:40 AM
#3
omg my air con system is a ****** mess! seems like the pipes are very bent from the damage to the car previously, either that or the bodyshop bent them whilst stripping the front end down. I've had a look at the pressure switch and tapped it quite a few times with a screwdriver as its quite far down compared to the diagram but it hasnt helped at all. i really hope i dont have to get it professionally repaired. in all honesty, i'd rather replace the whole system and have it all "how it should be" but i know that would be a mission and cost loads.
reganlives
27-05-2016, 03:40 AM #3

omg my air con system is a ****** mess! seems like the pipes are very bent from the damage to the car previously, either that or the bodyshop bent them whilst stripping the front end down. I've had a look at the pressure switch and tapped it quite a few times with a screwdriver as its quite far down compared to the diagram but it hasnt helped at all. i really hope i dont have to get it professionally repaired. in all honesty, i'd rather replace the whole system and have it all "how it should be" but i know that would be a mission and cost loads.

Recently Browsing
 1 Guest(s)
Recently Browsing
 1 Guest(s)
Related Threads…
Replies 20
Views 1,025
17-10-2017, 01:37 AM
Last Post by Sparkystav
Replies 18
Views 803
16-04-2017, 02:50 AM
Last Post by fluff
Replies 18
Views 724
06-11-2016, 07:46 AM
Last Post by jay_russell