lost power to my windows and gauge
lost power to my windows and gauge
Dark Samurai
03-10-2017, 10:39 AM #11May be a totally different fuse mate, as there are 2 plugs on the back of the cluster, one may be the gauges, one may be lights? so the light fuse may be working and gauge not working?
no wires in the car were removed when i did the clutch. just took the battery off so safty sake.
jay_russell
03-10-2017, 10:47 AM #13well the fuse keeps blowing.???? changed it and tried a 15 amp as the was no more 10 amp and that blew. so what might be causing this from a clutch change?
no wires in the car were removed when i did the clutch. just took the battery off so safty sake.
jay_russell
03-10-2017, 10:49 AM #14might have to check all the wires in the center consol just in case. i have my start switch in there and thats the only thing i moved in the car
Dark Samurai
03-10-2017, 10:52 AM #15May have removed a wire mate? Which could have been a ground wire sending too much power to the fuse nearest to it?
jay_russell
03-10-2017, 10:54 AM #16still it's to late to pull it apart tonight. will drive it to work and have a look in the morning. would this make for the whining noise then?
Dark Samurai
03-10-2017, 11:00 AM #17hmm dont think so mate, as it would have nothing to do with exhaust manifold/engine exhaust side, would it?
![[Image: Sig-enginebay.jpg]](http://i5.photobucket.com/albums/y179/SteveHammatt/Sig-enginebay.jpg)
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
03-10-2017, 11:29 AM #18I don't think that's anything to do with the noise, though. Is your Start switch wired into the gauge cluster circuit ?
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
steviewevie
03-10-2017, 11:31 AM #19ok, that was probably a silly question, because the Start switch is going to be wired to the ignition switch circuit. That uses a 20A fuse, so if that has somehow shorted out on the gauge cluster circuit then it would be blowing the fuse.
IS200 Turbo project now just about complete ! See my thread here and leave your comments.
Now running standalone Syvecs ECU and no stock ECU !
jay_russell
03-10-2017, 11:38 AM #20well i know were to look for the answers tomorrow morning. will be checking the start switch to see if anything is wrong there. thanks for the help guys. will find out whats wrong and let you know
3 Guest(s)
3 Guest(s)
Views 406
Last Post by
Views 1,073
Last Post by
Views 834
Last Post by
Views 817
Last Post by
Views 2,849
Last Post by