Head light opening
Head light opening
Anyone got any ideas, there is load of condesation in there, and want to get it nice and clean like the other one.
Seen a few posts and vids on actually opening up my headlight, but I am a little unsure as to what I would use to clean the inside of the headlight once I have opened it?
Anyone got any ideas, there is load of condesation in there, and want to get it nice and clean like the other one.
but make sure its all dry and gone before u reseal them think thats all i used
![[Image: FB_IMG_1474048273787_zpsnbfq6a3s.jpg]](http://i1227.photobucket.com/albums/ee440/davis5835/Mobile%20Uploads/FB_IMG_1474048273787_zpsnbfq6a3s.jpg)
jay_russell
10-12-2017, 09:18 AM #3why not just dry it out then take a small cotton ball with cleaner on it and clean it from the bulb hole and not even open it up. better to try and just seal it and leave the lamp as one
jay_russell why not just dry it out then take a small cotton ball with cleaner on it and clean it from the bulb hole and not even open it up. better to try and just seal it and leave the lamp as one
Good thinking, there is a lot of **** in there though. Will try that first though!
jay_russell why not just dry it out then take a small cotton ball with cleaner on it and clean it from the bulb hole and not even open it up. better to try and just seal it and leave the lamp as one
Good thinking, there is a lot of **** in there though. Will try that first though!
jay_russell
10-12-2017, 03:00 PM #6if you remove all the electrics from it and add a bit of water to wash it out first then leave it to dry with the lense face down in a corner were it's easy to get into to clean then after it's dried it's going to be just one part to clean.
1 Guest(s)
1 Guest(s)
Views 229
Last Post by
Views 398
Last Post by
Views 365
Last Post by