Hazard lights and drivers door open shut sensor
Hazard lights and drivers door open shut sensor
And on closer inspection, both front door switches arn't working.
If you open both the front doors, the inside light doesn't come on, neither does the light on the dash board. Also the rear boot release on the key fob doesn't work.
Could I have a fuse out??
Been out and had a closer look at the car today.
And on closer inspection, both front door switches arn't working.
If you open both the front doors, the inside light doesn't come on, neither does the light on the dash board. Also the rear boot release on the key fob doesn't work.
Could I have a fuse out??
i think its unlikely to be a fuse as i think the interior lights are all on the same fuse, the switch is just a short to ground so you can check this by taking the trim off locating the wire which goes up the B pillar
Dont cut this wire instead use a stanley knife and a multimeter hold the blade so its nicking through the PVC of the cable and then hold a multimeter probe on the blade other probe to a bare bit of chassis metal maybe the Seat belt tensioner.
If memory serves this should produce a short to ground if you push the button in then the ground be gone.
be sure to check the wire is connected and not floating loose in the B pillar...
Rabs
boot lock could be if its been locked by the key in boot lock as i think this stops it popping same as it disables the internal handle.
i think its unlikely to be a fuse as i think the interior lights are all on the same fuse, the switch is just a short to ground so you can check this by taking the trim off locating the wire which goes up the B pillar
Dont cut this wire instead use a stanley knife and a multimeter hold the blade so its nicking through the PVC of the cable and then hold a multimeter probe on the blade other probe to a bare bit of chassis metal maybe the Seat belt tensioner.
If memory serves this should produce a short to ground if you push the button in then the ground be gone.
be sure to check the wire is connected and not floating loose in the B pillar...
Rabs
james check the boot lock to see if it has been turned round if it has the disabling of boot opener could be that its in valet mode as for door switches check with a multimeter to see if they are switching n/o and n/c hope this helps mate all the best neil
iceman67 james check the boot lock to see if it has been turned round if it has the disabling of boot opener could be that its in valet mode as for door switches check with a multimeter to see if they are switching n/o and n/c hope this helps mate all the best neil
The key turning doesnt disable the key button, just the handle in the car.
![[Image: LexuS-Copy.jpg]](http://i65.photobucket.com/albums/h204/Sparkystav/LexuS-Copy.jpg)
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
Sparkystav
28-11-2017, 06:08 AM #16iceman67 james check the boot lock to see if it has been turned round if it has the disabling of boot opener could be that its in valet mode as for door switches check with a multimeter to see if they are switching n/o and n/c hope this helps mate all the best neil
The key turning doesnt disable the key button, just the handle in the car.
Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.
1 Guest(s)
1 Guest(s)
Views 1,175
Last Post by
Views 159
Last Post by
Views 286
Last Post by
Views 499
Last Post by
Views 461
Last Post by
Views 502
Last Post by
Views 285
Last Post by