Jimbobs Lexus IS200 Turbo!
Jimbobs Lexus IS200 Turbo!
so the gearbox fits the trans tunnel?
Yeah mate from what I can tell at present. Need to mount it and I'll check all clearances. May need to modify slightly for slave cylinder.
Sent from my iPhone using Tapatalk
Yeah mate front and rear
Sent from my iPhone using Tapatalk
Lol not a chance hahaha
Sent from my iPhone using Tapatalk
Well started today by sorting out my shifter location. Using an arm off of a BMW 1 series but still had to cut down. Try and get this welded up this week.
Also cut the shifter link I'll weld that tomorrow if I get home from work decent time.
Mounted my forge power steering reservoir
FPR mounted at the back on bulkhead
Intercooler put in place just need to mount to crash bar as just sitting at present. Think I'm going to cut some holes through it also as it does cover a fair portion.
Still need to get throttle cable bracket from a non drive by wire 1JZ
Main things still to do is gearbox support and propshaft but slowly getting there now.
I'll order my silicone bits so I begin to plumb it all in.
Still got to finish wiring in the Ecu but want to get some plugs so engine harness is not hard wired.
Hopefully I'll make some good progress and update again soon.
Sent from my iPhone using Tapatalk