is300 *is200

JapCarForum Cars, Cars, Cars! Project Cars is300 *is200

is300 *is200

Pages (2): 1 2 Next

iceman
Member

175

27-08-2020, 07:00 AM

just quick note.
any one no if the is300 head would bolt on to a is200 block ? As ive not seen both together i don't no.

iceman

27-08-2020, 07:00 AM #1

just quick note.
any one no if the is300 head would bolt on to a is200 block ? As ive not seen both together i don't no.

Sparkystav
Administrator

14,683

27-08-2020, 07:01 AM

no they wont, different sized cylinders

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

Sparkystav

27-08-2020, 07:01 AM #2

no they wont, different sized cylinders

Read my thread here: The Evolution of my Turbo Lexus from NA-Supercharged-Twin Turbo-Massive Single
Please leave your comments.

OutlawJapClub Admin Team

iceman
Member

175

27-08-2020, 07:16 AM

kk was just thinking as i no on some jap car u can use heads off others . Using a up graded head gasket to line up . Just a idea at the moment as i have a plan code named THE EATON project but a nuff said as no one has done it before if it works ital change the way people add power to there is200 but by the sounds and reading up on it ital only work with the is300 engine. But saying that it might just melt the engine .

Edited 08-10-2013, 04:51 PM by iceman.

iceman

27-08-2020, 07:16 AM #3

mattlaw
Senior Member

572

27-08-2020, 09:38 AM

Lets here the plan

mattlaw

27-08-2020, 09:38 AM #4

Lets here the plan

iceman
Member

175

27-08-2020, 12:09 PM

nope sorry

iceman

27-08-2020, 12:09 PM #5

nope sorry

mattlaw
Senior Member

572

27-08-2020, 12:26 PM

Forums are a place to spread ideas and share knowledge, maybe someone on here could help, maybe considering you don't realise a cylinder head off a 3 litre engine will fit on a 2 litre you're project will go know where and you'll end up with a collection of useless parts instead of a cool project

mattlaw

27-08-2020, 12:26 PM #6

iceman
Member

175

27-08-2020, 10:06 PM

it was a quick question as ive not worked on the 300 modal and yes it is possible on some jap cars and bikes as ive done it that's why i questioned it .

iceman

27-08-2020, 10:06 PM #7

it was a quick question as ive not worked on the 300 modal and yes it is possible on some jap cars and bikes as ive done it that's why i questioned it .

iceman
Member

175

27-08-2020, 10:35 PM

but all im going to say at this time is Eaton super charged and that's it but once ive found out the cost and when ive got a prototype going Il show the outlaws my idea first till then only me and one other outlaw about it. IM only holding off because its not been done and i wonted to be the first to have it running. Plus only one at hydraulic side of Eaton knows and that's me.

Edited 09-10-2013, 08:16 AM by iceman.